H-Tronic water level switch WPS3000

The H-Tronic water level switch WPS3000 monitors your water level with the help of a water sensor including a 10 m cable. When it comes into contact with the water, a relay switches on the socket on the controller. Ideal for technical facilities or in basements. You can also check the level of your pond and if the level drops, turn off your pond pump, for example, so that your pond is not pumped dry. Valves or warning devices can also be controlled. The relay can both switch the outlet on and off.

 

In the case of technical facilities or in basements, massive damage occurs time and again due to burst pipes, open windows in heavy rain or defective seals as a result of uncontrolled water ingress, to which it is not possible to react quickly enough. And it is also necessary to permanently monitor the liquid level in wells or containers. The new H-Tronic water level switch WPS3000 can remedy this – if water gets in or the previously defined water level is reached, a relay picks up and automatically switches warning devices, pumps or solenoid valves on or off.

 

The H-Tronic water level switch WPS3000 is suitable for all tanks made of concrete, plastic or metal and is quickly installed because all connections are pluggable. The switching point at any water level can be freely selected. The control unit is supported by a robust sensor. Due to the elimination of moving float switches, the H-Tronic water level switch WPS3000 works absolutely trouble-free. LED lights for "Mains", "Level" and "Rel. On" show the current status at a glance. A pump run-on time of 0...10 minutes can be set with two potentiometers to prevent the relay from constantly switching back and forth when the water is moving like waves.

 

- Switching point freely selectable at any water level

- For all tanks made of concrete, plastic or metal

- Switching output (Rel.) optionally configurable as opener or closer

- Remote measurement up to 25 meters possible via two-wire cable

- No dangerous mains voltage at the sensor

- Including robust water sensor with 10 m cable length and mounting material for housing (screws, dowels)

 

 

- Operating voltage: 230 V/50 Hz

- Power consumption: maximum 1.5 W

- Output voltage: 230V/50Hz

- Switching capacity: maximum 3000 W

- Switch-on or switch-off delay: 0...10 minutes adjustable

- Trigger sensitivity: 50 kOhm

- Sensor input: RJ 45 socket

- Protection class: IP 20