H-Tronic temperature switch TS 125

 

The H-Tronic temperature switch TS 125 can be loaded up to a maximum of 3000 watts and is the ideal temperature monitor for the garden pond, indoor storage or for the quarantine tank due to its easy handling. The display of the H-Tronic temperature switch TS 125 is digital and therefore much more accurate. The switching range can be set from -55°C to +125°C with an accuracy of +/- 0.1°C. The temperature in the pond water is measured using a stretchable temperature sensor with a 2 meter network cable. The exact temperature for switching on the connected device can then be set using the 3 buttons. The 12.7 mm large LEDs show the switch-on and switch-off temperature, the current temperature and the minimum or maximum value. A red LED light also signals "heating", a yellow "cooling", another lights up when the relay is switched on.

  With a separately purchased RJ45 network cable and an RJ45 double coupling, the temperature sensor can optionally be extended to up to 50 meters. Storage of the programmed switching waves even in the event of a mains voltage failure, automatic restart after a power failure.

 

If the actual temperature is within the temperature window after the on/off switch temperature (heating) has been set (e.g. the relay should switch on when it falls below 20°C and switch off again at 25°C and the current temperature is 23°C). the relay does not turn on. The relay only switches on when the temperature falls below 20°C and drops out again when it reaches 25°C. Conversely, this also applies to the “cooling” area.

 

 

- Operating voltage: 100 - 240 VAC

– Power consumption: approx. 2 VA

– Switching capacity: maximum 3000 watts

– Output voltage: 230 volts / 16 amps

– Measuring range: -55 to + 125.0°C

– Accuracy in the range: -55…-10°C = +/-2°C; -10…+85°C = +/-0.5°C; +85…+125°C = +/-2°C

– Display: 0.1°C

– Min./Max. display

– Degree of protection: IP 20

– Ambient temperature: - 10 to + 50° C

– Housing dimensions 160 mm x 80 mm x 60 mm